Product description:
| Model number: | HM-RO-E | Feed water TDS biggest limit | ≤1000 PPm |
| Brand: | Vamia | Water pressure: | 0.1-0.3MPa |
| Type: | Reverse Osmosis | Water temperature: | 5-45C |
| Capacity | 75GPD RO membrane | Design pure water flow | 11.8L/H |
| nstallation Method: | Under the stage or on the wall | Power: | 24V 1.5A |
| No.of stage: | 5 | Pressure tank: | 3.2G |
| Water purification method:PP cotton +active carbon +RO+active carbon | |||
| Size:475*162*375mm | |||
Main Features:
1.The Filter precision is 0.0001 μm, makes the filtered water includes water molecule only,make sure your drinking water clean and safety.
2.Low waste water rate , saving more water.
3.Digital design for display the water system work situation.
4.Humanity design for easy replace the filter cartridge
5.Long time services life
Packing: in cartons.
Delivery: within 15-20 days after receiving the payment.
MOQ: 1 Set.
Payment terms: L/C.T/T.Western union.
We can accept OEM or ODM.
Installation Note:
1. Do not install under sunlight;
2. The product working temperature 5 to 45 degrees;
3. The product can not filter hot water, please do not connect to water heater.
4. Before use it, installation of the product should be fixed to prevent product
turn down;
5. If the tap water pressue is higher than 0.4Mpa, please install the pressue
limiting valve before the product;
6. Do not arbitrarily remove the parts on the product, to prevent leakage and damage
to the machine;
7. PE pipe and fittings should installed in place;
8. Water tee, no seals should be wrapped with raw materials, there is a ring of raw
materials can not be wrapped around the band;
9. After the installation is completed, you should turn on the water and gooseneck
faucet, after 5 minutes, close gooseneck faucet , and check there leaks;
10. Pure water end and wastewater end can not be inversely connected.
OEM Policy:
We can print your LOGO and custom packaging of our products, if you order exceeds 1000 units or above;the imprinting service and packaging will be free, otherwise it will be charge for printing and packaging at cost. The procedure is very simple;after choosing the product, you must provide us your LOGO/Packaging ARTWORK(digital format PSD,AI),and we will send you back a visual of the labeled product. If you accept the size and position, we will proceed to mass production.
Installation:
RO Membrane instruction:
Description of 5 stage:
